I´m currently trying to uploade the bootloader on the PIC32 (I´m using the one listed on the forum UDB32_MX2_DIP.hex https://github.com/chipKIT32/chipKIT-digiboot/blob/master/BootloadersCurrent-hex/U

Hello @wjcroft I finally succeeded to upload the „device“ and „host“ code. Silly enough, I forgot to add a file in the Rfduino library and that was the only damn problem. I’ve built the dongle and in

from Tool" and then clicked Connect. PICKit3 detected the PIC32 chip successfully and this was the initial log output:

https://github.com/sergev/pic32prog/wiki/Using-PICkit3

* Used a PICKit3 to program the bootloader hex onto the PIC32 with MPLAB IPE (v5.15) via the headers.

I have Microchip PicKit3 working OK and I have the OpencBCI.hex code generated by the Arduino IDE.

1) Is the Pickit3 the only way to do it? If affirmative, is there a tutorial so I can follow some "safe" steps?

I hope you can get your Cyton back to working order using the above page. If the bootloader is indeed scrambled, then you may well need the Pickit3.

 How could I reprogram it? Is the PICKit3 neccesary? 

* Used a PICKit3 to program the bootloader hex onto the PIC32 with MPLAB IPE (v5.15) via the headers.

http://openbci.com/forum/index.php?p=/search&Search=pickit3

I collected the Cyton board from github, programmed it via pickit3, updated OpenBCI v3.1.2

Connect Pic32 with pickit3 using the PIN (Google the pins)

Hi ahsanicCan you guide me about burning code in pic32 using pickit3?

I have burned code into pic32 using pickit3 and it works like charm.

Hey I was finally able to burn code in pic32 using pickit3. Now when i start processing it connects both dongle and device. It even shows the screen where signals waveforms are generated but there is

I upload the boot loader to the board with a Pickit3 which all goes fine(Blue led flashing, update succesful) Though when i then try to enter boot loader mode nothing happens, i.e. no flashing LED. Th

I will get a tutorial up soon. For now, please connect the picKit3 thusly:

I'm sorry to hear you bricked your bootloader. I will get a tutorial up soon. For now, please connect the picKit3 thusly:

I have tried the MPLAB X IDE v2.35, the UDB32-MX2-DIP.hex file is import from the File>Import>Hex/ELF..File, and the hardware tool is chosen as PICkit3/ SN:BUR132284452. And I don't do a