Cyton

Sub-category for the Cyton 8/16 channel system

Discussion	Started By	Replies	Views	Most Recent
16ch Daisy v1 firmware -- Missed packets?	RPSpicer November 2016	7	316	likeoo January 2017
Problem using analog PIN	davide_93 January 2017	12	728	davide_93 January 2017
Daisy Module Not Recognized by GUI	Jabernet January 2017	0	264	Jabernet January 2017
Change SYSCLK frequency of PIC32 in 32-bit board	meagmohit January 2017	1	446	meagmohit January 2017
SD-only version for increased sample rate and interrupts	yj May 2016	18	1.3K	yj December 2016
Problem uploading firmware to ATmega328 (8-Bit board)	BerndB December 2016	0	589	BerndB December 2016
8 channel board to Android (via Bluetooth 2 or BLE)	f10-forever November 2016	14	1.5K	wjcroft December 2016
Unexpected noise with Daisy	sardet December 2016	2	655	sardet December 2016
All 8 channels RAILED with headset	tiger-cheng November 2016	12	1K	tiger-cheng December 2016
V2 firmware, multiple OpenBCI boards connecting to one PC?	kakotopia November 2016	1	343	wjcroft November 2016
using interrupts vs. polling of ADS1299 1 2	hitheshaum June 2015	36	2.1K	yj November 2016
Issues with V2 firmware and lead off detection	sardet November 2016	6	295	pushtheworld November 2016
Random high intensity signals on the electrodes	vaibhav2912 August 2016	17	1.1K	vaibhav2912 November 2016
Daisy Channels 9-16 data low uV, ch 1-8 ok	octobot October 2016	2	179	octobot October 2016
Soldering 16-Channel OpenBCI Kit 1 2	chipaudette January 2015	35	3.2K	ZeroWitOne October 2016
Send less than 8 channels data	christihan September 2016	15	613	wjcroft October 2016
To use the pin D12 as an input	yj October 2016	2	250	wjcroft October 2016
All 8 channels railing on headset	trainlevel2 September 2016	3	262	wjcroft September 2016
My Linux does not recognize the dongle	victoria_peterson August 2016	3	785	cfausn September 2016
after using for a year, power LED getting dim	Skalbe August 2016	3	206	wjcroft August 2016
OpenBCI_Python and Unusual Dongle Behaviour	samuelpo94 August 2016	2	231	samuelpo94 August 2016
No EEG signal (.1 uV only), on new board	elizondo93 November 2015	29	901	swap July 2016
Init timeout error when writing to SD card	armz12 June 2016	1	278	yj June 2016
8 bit or 32 bit board?	ltulley October 2014	21	3.1K	nobletime May 2016
Unable to read data and "Read page failed" on flash	pbnsilva May 2016	5	484	pbnsilva May 2016
Ch 1-8 OK, Ch 9-16 Railing?	Dreaming_Geek December 2015	14	2.3K	biomurph May 2016
Unknown Noise Source while Recording EEG with 16 channels	asd786 April 2016	2	301	wjcroft April 2016
what range of channel numbers are shipped with OpenBCI boards?	eohan April 2016	1	195	eohan April 2016
data stream freezes after some minutes of use	Rogerio January 2016	26	1.2K	leka0024 April 2016
Data Streaming to SD Card without PC and Dongle	asd786 March 2016	8	813	biomurph April 2016