Soldering 16-Channel OpenBCI Kit

2»

Comments

  • samuelpo94samuelpo94
    edited September 2016
    [original new thread titled: Daisy Module]

    Hi there.

    I have a question regarding my Daisy Module. I have tried soldering the sockets to the boards, but it seems to not work. I suspect that it is due to faulty soldering. However, I came across a page regarding the reworks done on the Daisy Module. I would just like to ask if the Module I got has been reworked or not.


    Regards,
    Sam
  • wjcroftwjcroft Mount Shasta, CA
    Hi Sam. We already answered your question before previously on this thread. I merged your question into the existing thread here. Can you look over the previous posts on this thread to see if that gives you some insights on how you can resolder your daisy? Do you have a solder removal tool there (solder sucker)? 


  • ZeroWitOneZeroWitOne
    Hi, 

    Its either the daisy module or the board. When I connect the reference (SRB2) in the daisy module, i get correct EEG readings for the channels connected in the daisy, and railed for the main board, and vice versa.

    Please if you know why is that happening let me know, as i am running out of ideas. 

    Regards,
    Ahmed
  • wjcroftwjcroft Mount Shasta, CA
    Zero, hi.

    I merged your question into this existing thread. You need to make a Y cable to bridge the two SRB2 pins. See previous posts.

    Regards,

    William

  • ZeroWitOneZeroWitOne
    Hi Wjcroft,

    Thanks, to be honest i thought you guys took care of that. was trying to avoid more hardware work-- was relieved after the soldering!.

    Regards,
    Ahmed 
Sign In or Register to comment.

© Vanilla Keystone Theme 2024