xanderli12_
xanderli12_
About
- Username
- xanderli12_
- Location
- Nigeria
- Joined
- Visits
- 24
- Last Active
- Roles
- Member
- Location
- Nigeria
- @@xanderli12
- Aminone Akpos
Comments
-
@rhys151 said: Hi, thanks for replying. I solved it, I had the serial monitor open in the Arduino IDE which stopped the GUI from being able to communicate with it. Clearly, I'm new to this. hey rhys, i have a similar problem. it does not …
-
No they haven't yet, thank you for your response
-
Hey, I still have this problem and even tried uploading a firmware3 but the ganglion failed to connect
-
Yes I have sent them an email. Also The native mode gave the same error message too on my system and the other system I tried it on
-
Hey thank you for responding, I've tried this and I'm still getting the same error message. I even tried it on a different system. I also tried updating the firmware of the ganglion but the board itself fails to connect.