viyyer
viyyer
About
- Username
- viyyer
- Joined
- Visits
- 39
- Last Active
- Roles
- Member
Comments
-
I used the default code for RadioDevice32bit and RadioHost32bit and uploaded them. The channel number mentioned in both of them is 20.
-
Really, I am so thankful for this extensive support. BTW.. it quite interesting to see the 7 follows 5 and not 6 , maybe 6 is not a very lucky number for BCI people (just kidding :-) ) . I have tried the instructions on the guide. One thing is …
-
I am just uploading the new firmware. Update: successfully programmed the device and the host . But since then, the Bluetooth doesn't connect at all.
-
sorry here is the screenshot of the new version of openbci gui let me get the capacitor and breadboard for doing firmware upgrade.
-
I have been successful at updating the PIC. but the radios, it is quite confusing I have tried following this document (https://docs.openbci.com/docs/02Cyton/CytonRadios) but I have not been successful yet to upgrade the radios. It will not be easy…
-
Sure, Yes, I upgraded the firmware for the cyton board. Now I was able to see something on the GUI . Only thing was that it suddenly stopped showing anything on the screen. That is what I meant by "not delivering" to the PIC controller.
-
I wasn't using my openbci for a while. I figured there were a few issues . one was the firmware upgrade. which I just did. and the second one is that the ADSP was not delivering... it is still not delivering data consistently.
-
Here is the screenshot. That one did not show the data. Though there is not much shown in the screen.
-
Cyton version is v3-32 . I am using the 2.0 version openbci GUI. from version 3.0 onwards. I was unable to get the board connect with GUI.
-
I guess I want to know the weight of the board, dongle and connectors. I am guessing its a few hundred grams or under a pound.