stuffdeveloper
stuffdeveloper
About
- Username
- stuffdeveloper
- Location
- Indianapolis, IN
- Joined
- Visits
- 10
- Last Active
- Roles
- Member
- Location
- Indianapolis, IN
Comments
-
I guess my question is more around whats happening on the hardware vs what the gui is showing. So is everything referenced to the 'bias' pin as the ground on hardware and the gui is just displaying everything referenced to SRB2? So the SRB channels …
-
Yep, that explains how to setup up but not the why on things are the way they are. Say I wanted to recreate a personal version of the cyton that is more tailored to my application, its useful to know these details I think
-
So the ground for the measurement is the 'Bias' pin and then each electrode pin is differentially amplified relative to SRB2? This type of info doesn't seem clearly laid out in the docs or am I just missing it?
-
The board itself is capable of doing this right? The issue is transmitting the data? If I connected the board directly to the dongle or saved the data on a SD card, there should be no issue?
-
This would be a poor anti-aliasing filter for a fs=250 Hz, right? The cutoff frequency is > 7kHz