strator
strator
About
- Username
- strator
- Joined
- Visits
- 9
- Last Active
- Roles
- Member
Comments
-
The distance between the dongle and the board was about 5 cm. However, after turning the OpenBCI off and on while holding the reset button, the distance does not matter. Thanks Torsten
-
To answer my own question: I got it working using a suggestion from biomorph: Turn on the board after the dongle is plugged in (start the Host radio before the Device radio) Hold the RST button down, turn on the board, then press the PROG button …
-
Hi Yannick, thanks for your response. Yes, I've tried it and it makes no difference. I have tried all other advices found in the forum, too, without any success. Torsten
-
Anyone found a solution for this problem? I'm working on Windows 10 x64, updated Dongle & Board Firmware (btw, pressing the pins to the pads on the board is really akward), tried it hundred times but always get a verification error: Program…