shanks
shanks
About
- Username
- shanks
- Location
- Vienna
- Joined
- Visits
- 41
- Last Active
- Roles
- Member
- Location
- Vienna
Comments
-
I tested it now. Only Channel 1 has the noise even if I attach it to the Reference pin as you mentioned. It looks like this: https://www.dropbox.com/s/1nbir2itd2tyimp/Unbenannt.PNG?dl=0
-
ok thank you for your help! I will test the Ganglion tomorrow.
-
Ok I understand. Does the cyton also not have electrostatic discharge protection? I need to recheck that, but I don't have them with me right now, but with no electrodes attached they did not have any noise. Best, David
-
Hi William, Thank you for your answer! No, after I disassembled the mounting and only used the spiky electrode with the electrode cable it still had noise on them. I tested a second Ganglion with the same spiky electrode and same electrode c…
-
Hi,I printed the MarkIV with a CR-10s with PLA filament. I used the model which is cut in half. I rotated each half approximate 45° and created support with 4mm and 45°. The temperature of the bed was set to 65° and the nozzl temp. to 210° Best …
-
[new thread titled: hex crimp nuts and the ear clips] Hi, has anybody found a store (or multiple stores) in Europe where all the parts for the electrodes can be bought? I am particularly looking for the hex crimp nuts and the ear clips. I c…
-
Hi William, Thank you for the link, I will definitely check out the Node.js code on Github! My first steps to get a better understanding on the communication between the PC and the Hub was, that I tried to implement a TCP/IP communication betw…