Comments

• none needed, thanks a lot for your work on this board, it is really appreciated.

  in sending 'v' as a command Comment by remy October 2017
• oh ok thanks

  in sending 'v' as a command Comment by remy October 2017
• Thanks, i was trying to follow the cython sdk which mentions: "Changing the sample rate requires sending a v or soft-reset to ensure all systems are correct." after the ~(COMMAND) option

  in sending 'v' as a command Comment by remy October 2017
• Thanks for your fast reply AJ,That makes sense , i should have thought of that. I have a Cyton @ v3.0.0 and a shield    @ v1.1.3 Do you know a good way then to switch the sampling frequency?  Thanks again.

  in sending 'v' as a command Comment by remy October 2017
• PS: when i do not post 'v' and ask for something else than 250, it either blocks, or sends just a few samples. Thanks again

  in sending 'v' as a command Comment by remy September 2017
• Definitely, i assumed i did something wrong so i didnt see it as a bug, but i will log it there asap. Thanks for your quick reply.

  in record to sd @1kHz Comment by remy September 2017