meagmohit
meagmohit
About
- Username
- meagmohit
- Joined
- Visits
- 103
- Last Active
- Roles
- Member
Comments
-
With the release of new OpenBCI GUI, having the networking capabilities, is it possible for OpenBCI GUI to receive stimulation externally through TCP port, and synchronize wrt. time while recording the data in an external file for analyzing it later?
-
All, figured it out, if anyone wants to do the same. Just have to add one more jumper wire from the 3V3 pin of Dongle to pin 13 of RFDuino on device. It's not too hard to hold the additional jumper wire. Hope it helps!
-
I got it. Use 'OSCCONbits.PLLODIV = 0bxxx;' in the firmware code. Check the datasheet of PIC32 to see the divider bits.
-
Hi, Thanks William and Kartik for your comments on products. Cognionics is way expensive. I am now thinking about purchasing, g.tec G.GammaCap with G.Sahara electrodes. I want to connect these electrodes to openBCI module. Can you help me…
-
Hey, Have anyone tried any dry-electrodes sensors which can be used like a wearable headset. For Ex. Emotiv Epoc+ The poblem with this module is its electrode positions does not involve C3, C4,Cz positions which are crucial for motor imagery…
-
@cbond21 wrote: Hello, I am a PG researcher from India. I want to know which software is more compatible with the R&D kit of openBCI? And also if anybody have worked with openVibe please tell me if it is compatible with the system. Thank yo…
-
@biomurph Thanks for your reply. I was trying to figure out the problem and saw a defect(might be) in hardware. I am attaching a pic of my daisy module here. Image1 : http://postimg.org/image/5op3tz4g5/ Image2: http://postimg.org/image/m07ggka…
-
I saw the above posts in which people tried to resolder and tested, I tried same 2-3 time but didn't work
-
Hi, I am encountering same problems when I attached daisy module. I checked the soldering 4-5 times using Multimeter and it shows all connected. I've tried using Processing-openBCI-GUI (Windows) as well as python-interface(LINUX). Processing…
-
Ohh yes, you are right. I am sorry for my wrong interpretations. Just for the clarification purposes, did you measure the potential difference between C3 and Cz? And what did you use as BIAS? or turned the BIAS off? I did several experiments…
-
Hi, I read all of your blog posts. I was reading about mu-waves and its amplitude should be decreased when imagining/moving hand/feet. In your case its amplitude increases, which I think is due to may be movement related frequencies? Mohit
-
How can I measure the electrode impedance using my openBCI module?