inez_wihardjo
inez_wihardjo
About
- Username
- inez_wihardjo
- Joined
- Visits
- 0
- Last Active
- -
- Roles
- Member
Comments
-
why is it also that my device ID is 0x00?
-
Just realized something, what am I supposed to do with pin 4?
-
Hi Chip, Thank you for your explanation.. It seems plausible. I am not using the software that came with the TI though, but rather, I am using one of the codes from your sandbox. The Stream raw data.. But yea, the register value seems to keep on …
-
Hi Chip, No, Im not using the OpenBCI board... am using the TI evaluation module... Inez
-
I see... thing is actually I plan to connect to FPGA not Arduino later... Will the OpenBCI board work as well? Also, I just tried your code on your sandbox on Streaming Raw Data. Why is it that when I have nothing connected, and I just print the …
-
Hi Chip, I see... And all examples worked perfectly fine for you? Did you use any logic shifter, or just connect it directly? The thing is I am not using the OpenBCI v1 and v2 board, but rather, the evaluation module for ADS1299 produced by TI…
-
Hi, Thanks for sharing the resource. It is mentioned there that since we need 3.3 V, we can only use Arduino Due? Is it true? I cannot use UNO? What if I use a logic shifter to convert 5V to 3.3V? Looking forward to hear from you. Inez
-
Hi, Yup, I saw that... But as im connecting it to the Evaluation board, I dont have direct access to those pins on the ADS1299 chip, rather, is to the J2 pins on the module. http://www.ti.com/lit/ug/slau443/slau443.pdf On page 16, it gave me t…
-
Hi, What about the pins at the ADS1299 side? Inez