hans
hans
About
- Username
- hans
- Location
- Berlin, Germany
- Joined
- Visits
- 13
- Last Active
- Roles
- Member
- Location
- Berlin, Germany
Comments
-
@biomurph + @wjcroft: relief! I just programmed the dongle RFduino with the host.ino with channel 4 and now communication works with all 16 channels! Now we see Rx (green) and Tx (red) LEDs busily blinking and all works fine. It seems that the do…
-
@biomurph , thanks for the quick answer. The communication between dongle and board always timed out. The dongle bag indicates "openBCI 32bit channel 4" and the board bag "16chan channel 4". But I wonder that the red Tx LED doesn't flash when the do…
-
Hi All, I am unable to establish a connection between the dongle and the 32 bit OpenBCI board. My setup is as follows: The switch on the dongle is set to "GPIO 6". When I plug it into the USB port the red TX led flashes once and the blue led light…