graumbl
graumbl
About
- Username
- graumbl
- Joined
- Visits
- 13
- Last Active
- Roles
- Member
Comments
-
I recently encountered an error that might be simlar while trying to move my project to a new machine (suse not arch linux). RunnableTask.run(): A caught exception occured on thread main-Display-.x11_:0-1-EDT-1: RunnableTask[enqueued true[executed f…
-
Thank you! Uploading the firmware to to board itself was enough - I'm getting proper signals! Thank you very much for your guidance and help!
-
I don't know what exactly happened, but once I hit autoscan in the openbci-radio-configuration-utility it worked and now they are connected. I'm even able to change the channel in the 'normal' OpenBCI GUI. I didn't expect the corresponding autoscan …
-
I see, I'm supposed to do both 1 & 2...I really should fetch some sleep before I continue. I just skipped that because I thought it would only belong the GUI that already runs. Thank you for the clarification. I'll post later (tomorrow?) how it…
-
Thank you for the link! I just tried to set it up with processing and complains about librarys like ControlP5. Am I supposed to install them one by one by hand, or is there a simpler solution? I ran some tests to clarify my statement from before: T…
-
I have the OpenBCI GUI installed and status displays 'Failure: System is Down', get channel results in 'Failure: Host on Channel number: 1'. If I replug the dongle the channel number shifts around without any apparent rule. If it's still worth to t…