Comments

• Thanks for the reply Wjcroft and Biomurph, So if I set up a separate power supply for the ADS daughter card and give the pin connections as mentioned above with a level shifter and flash chips code to my arduino uno it should work straightaway?

  in Brain Controlled Wheelchair with TI Eval module > Arduino Uno > PC Comment by gokul_96 April 2016
• Hello Wjcroft, so after many hours of experimentation and using variations of chips code, it does not really seem to be working i think we are going wrong somewhere in connecting the pins from the arduino to the ADS1299PDK the TI software which i fi…

  in Brain Controlled Wheelchair with TI Eval module > Arduino Uno > PC Comment by gokul_96 April 2016
• Thanks for the input Wjcroft, ill be trying it right away and ill let you know about what hapened what command to use to set which are reference and bias electrodes and number of channels to use ? also single-end electrodes or double end elect…

  in Brain Controlled Wheelchair with TI Eval module > Arduino Uno > PC Comment by gokul_96 April 2016
• Hello Wjcroft thanks for the reply, yes I have seen and tried to make sense of all other discussions here, I still seem to be lost, what about the pin connections ? Is there any document which explains that? And as for chips code what would I have …

  in Brain Controlled Wheelchair with TI Eval module > Arduino Uno > PC Comment by gokul_96 April 2016
• Thanks biomurph, yes I was looking at the code I can't seem to understand how to change numer of channels i want and also is there any difference between single ending and double ending the input if yes which is less complex and gives viable signals…

  in Brain Controlled Wheelchair with TI Eval module > Arduino Uno > PC Comment by gokul_96 April 2016