Comments

• I am using PLA and just trying to get it printed for teting. also, has anyone tried 3rd part interfaces?

  in Gcode 'support settings' for printing Ultracortex? Comment by chchoe78 November 2020
• Thanks for the advise. Hope my prints come out decent.

  in Newbie here trying to get some direction and have some questions answered Comment by chchoe78 October 2020
• Not clear your comment "have the Cyton somewhere else for less interference" the inverse is actually the case. A compromise might be to clip the Cyton to your shirt chest front, which would allow shorter cables. But the Cyton positioning directly on…

  in Newbie here trying to get some direction and have some questions answered Comment by chchoe78 October 2020
• If everyone is thinking the same, then nobody is thinking.

  in Newbie here trying to get some direction and have some questions answered Comment by chchoe78 October 2020