Comments

• No. It seems the 32-bit boards use the lower set of pins for electrodes whereas the 8-bit boards (or at least a photo somewhere in the instructions) use the upper set.

  in Channels stuck at "RAILED" Comment by baobab January 2015
• Thanks for posting this. I take it your chamois-wrapped cup electrodes are also meant to be used with saline solution? And suitable as long as you don't care about very low frequencies?

  in Velcro saline sensor headset Comment by baobab January 2015
• Thanks. I'm going to take a shot at putting something like this together.

  in Saline-based electrodes (no paste needed) Comment by baobab January 2015
• Just tried it. Using the lower pins did fix my issue. Thanks!

  in Channels stuck at "RAILED" Comment by baobab December 2014
• Here's a great 2010 survey on the state of non-medical BCI tech, from electrodes, to training/calibration, to control latencies: http://www.ncbi.nlm.nih.gov/pmc/articles/PMC3002462/

  in Recommended books Comment by baobab October 2014