arpit
arpit
About
- Username
- arpit
- Location
- india
- Joined
- Visits
- 53
- Last Active
- Roles
- Member
- Location
- india
Comments
-
The files present in the Follwoing link : https://github.com/OpenBCI/Docs/tree/master/assets/MarkIV/STL_Directory/Injection_Molded_Parts can be proceed for 3d printing ? please give some insight regarding that awaitng for response. Thanks, arpit
-
@alwayswearshats said: Part of the benefit of DIY is learning how to DIY. There is enough information on this forum and online to make your way through. It will take time but you can do it. Unfortunately, putting a tutorial together would …
-
@alwayswearshats said: They were definitely not a smooth fit at the start. Playing around with the scaling and working-in the rough edges of the grooves a few times worked fine for my purposes. By wire crimp nuts, are you asking about the …
-
Respected sir, Were should i get non 3d printed parts ? Or there are any alternatives available so that it will work with ultracortex headset ? Awaiting 4 your response. Thanks arpit
-
Respected sir, Still i didn't get proper steps what to do ? And how ? I m beginner.please give proper guidance How to build cyton and upload the bootloader and firmware without using rfduino or How to do this by using wifi shield ? Awaiting for…
-
RFD22302 is also not Available !!! what should i do now ?
-
@kino009 said: With some of the components reaching EOL, i was wondering if the community planned to update the BOM or design procedure. Im trying to build this for my major project. I was wondering where to start, when it came to mind tha…
-
I had also gone through this page: https://openbci.com/forum/index.php?p=/discussion/1701/rfd22301-is-not-available-reason-obsolete But i didn't get proper steps to proceed further !! please give some guidance regarding How to make cyton board …