MdSakibulAlam
MdSakibulAlam
About
- Username
- MdSakibulAlam
- Location
- Bangladesh
- Joined
- Visits
- 65
- Last Active
- Roles
- Member
- Location
- Bangladesh
Comments
-
Hi wjcroft ,Thanks a lot,Good news is ,its working ,i can control led using focus widget.
-
Thanks a lot for your response,do you refer anyone with the arduino part?Do i have connet RX TX with ganglion board or something else?or any project related to this
-
The baud rate is same in both rate,can you explain RX TX to TX RX thing?
-
Yes i have done that,also pass 1 or 0 to turn on/off through serial terminal.
-
Yes,all done, when its focused the gui sending true,and when not focused sends false but arduino does not respond on this,i also separately use arduino serial terminal to pass value.
-
Hi, Everything running well ,now i can focus,but i am stuck at the last part with ardunio,i use the same code given in w_focus folder as instructed but the led remains off. Thanks
-
I have tried everything, i find in forum but i can not turn on led placed on arduino,anyone here help me to sort out the problem. Thanks
-
Hi,I have go through the thread but my setup is not responding till now.What else i can do. Thanks
-
Hi,I figure out what value is gui passing to arduino,it sends true or false basis on focused sate,but now how can i use this value with arduino? thanks
-
Hi,Using network widget i am trying value to ardunio,the problem is when i select TimeSerise,FFT in Data Type the connected led begins blinking that means some value is passing but when select Focus the led stops blinking.Is there any problem with F…
-
Channels are not giving right data,how to reduce those data,even i concentrate channels show more then 100 uVrms.I have go through pde files mentioned above.How to edit those .pde file and load to ganglion board? Thanks
-
Hi,My ganglion board giving data in high frequency ,how do i solve this problem? Thanks
-
Hi William,I have already go through previous links and also connected arduino using network widget but after that how do i control the led?Now i am stuck in arduino coding part. Thank you
-
Hi William,Can you give any source code for arduino that shows or collect data from ganglion board and turns on/off led?As i am new with ganglion board,everything seems fishy.It will be very helpful if you provide exact source or any tutorial.Thanks…
-
Hi William, I just want to on-off a speaker using ganglion board through ardunio.What i have to do to establish connection between these two. Thank You