HowardK
HowardK
About
- Username
- HowardK
- Joined
- Visits
- 34
- Last Active
- Roles
- Member
Comments
-
@retiutut So I need to change the number to 1000 and 500 if my Sampling rate is 1000? > https://github.com/OpenBCI/OpenBCI_GUI/blob/58fb49495841ac2fbabc68d4b69d9b0c7a8bffe0/OpenBCI_GUI/DataSourceSDCard.pde#L46 https://github.com/OpenBCI…
-
@retiutut said: The SD card conversion in GUI v4 might be hardcoded to 250Hz for 8ch and 125Hz for 16ch. Try @wjcroft's suggestion. GUI v5 SD card playback is also hardcoded at the moment to 250Hz and 125Hz. The reason is that the SD card …
-
@wjcroft said: The header in the GUI CSV text file is unchanging, would be my guess. You should be able to tell by the length of your file, the number of samples / lines will be roughly seconds * 1000. Does it mean that I have to modify t…
-
https://github.com/OpenBCI/OpenBCI_Cyton_Library/pull/96 https://openbci.com/forum/index.php?p=/discussion/2435/over-250-sps-to-sd-card-using-bluetooth-dongle @wjcroft How can I make sure the SD card data I got is at SPS==1000Hz? I use S…
-
This is likely caused by an error/glitch in the firmware. You may need to re-flash the firmware to the Cyton. @wjcroft Do you agree that HowardK should re-flash? Let's get confirmation before you try this. @retiutut @wjcroft Thanks for your…
-
@retiutut said: @HowardK I am unable to download the file you shared to test. Can you make it public please? Is it available now?
-
@wjcroft said: Howard, hi. There is a firmware fix you can try, that enables faster SDcard recording, using just Bluetooth, see. https://github.com/OpenBCI/OpenBCI_Cyton_Library/pull/96 https://openbci.com/forum/index.php?p=/disc…
-
1
-
@retiutut Did you see the .txt file that I had attached? Both serial monitor and GUI asked me to"try the valid file". Here is the error message" Tried to load anun supported file for platback! Please try a valid file" I am wondering why the .txt fil…
-
I was suggested to mention @wjcroft ,@retiutut and @evaesteban