EstherBarnaul
EstherBarnaul
About
- Username
- EstherBarnaul
- Location
- Cologne
- Joined
- Visits
- 14
- Last Active
- Roles
- Member
- Location
- Cologne
Comments
-
Hi William, No, I only double clicked it, and when I then said it should open the software because I trusted it, it did not work. With Control it worked. Thanks a lot!
-
Hi William, The message is in German: "OpenBCI_GUI“ kann nicht geöffnet werden, da Apple darin nicht nach Schadsoftware suchen kann.". It says that Apple cannot look for malware in the software, so it cannot open "OpenBCI_GUI". Then comes the part …
-
Great! Thang you very, very much!
-
Thanks a lot again. I hope I will be able to get into this and to work sensibly... There are no courses you give, by any chance. As mentioned in another post, my problem is that I am the only one around working with EEG (in fact, I am the only one …
-
Dear William, Thanks a lot. Just to make sure: This means that basically three electrodes on the cap will not be connected to anything? And before I set up another new discussion: do you know which of the electrodes are best for n400 and p600 test…
-
Hello, me again. I have now (hopefully) connected everything correctly. However, the cap comes with 19 electrodes (and cables respecitvely, but the board only offers 16 connections. Is this correct? If so: how do I decide which electrodes to use? …
-
Thanks a lot! I will try this out and will let you know how I managed to do it. Hope it will be a a picture of a happy person.
-
Sorry, yes I am using an electrode cap. Stupid question: the extra wires for Reference and Bias are not the y-cable?
-
Thanks a lot. I think my question is much more basic than this. I have this device: https://github.com/openbci-archive/Docs/blob/master/assets/images/touch_proof.jpg?raw=true and it has ten terminates. In this picture: https://github.com/op…
-
I looked at the tutorial, and there it says that I should use the eight channels. The (upper) SRB is already used for the cable that connects Daisy and Cylon. It is probably not important which colour is used for which channel, and maybe I will need…