Alejandro
Alejandro
About
- Username
- Alejandro
- Location
- Ireland
- Joined
- Visits
- 25
- Last Active
- Roles
- Member
- Location
- Ireland
Comments
-
No, I never got a reply from him at that email address. But university filters have gotten ridiculous lately so it could be that may e-mail never reached him.
-
@wjcroft said: Alejandro, this is Dan's page at Cornell, with contact info: https://www.vet.cornell.edu/research/faculty/daniel-fletcher-phd-dvm-dacvecc I wasn't able to get in touch with Dan, but just FYI we were able to finish th…
-
Thanks William, Much appreciated! I'll reach out to him directly.
-
Hi Dan, thanks for this contribution. We need to modify some parts of your design to adjust for some parts that cannot be sourced exactly as you have it anymore. Is there a possibility to have the CAD files that we could make modifications on? T…
-
Hi @robertoostenveld and @retiutut I see the same issues but with a Cyton board. I have a very intermittent direct mode functionality, and when it manages to connect, the data stream is empty. No error message is shown but the raw output file only…
-
@wjcroft, @retiutut, @daniellasry, I just ran the GUI in Processing. There, the digital read functionallity there works fine and the raw file outputs the digital channels as it is meant to. So, the issue is narrowed down to the stand alone release…
-
@wjcroft, thanks. I have tried to look into it. The GUI console log does state that the hub is sending the command 'board mode /DIGITAL' but the raw output file is recording as if the accelerometer data was being recorded (i.e 8 channels columns +…
-
Hi, I am also experiencing the same issue with my Cyton and the latest firmware. It was working quite stable and then it became this 'random' value sequence which actually is the same the analog read values. Any thoughts on this? Kind re…