Pin Connections to Program Device RFDuino [while providing power from dongle 3V3]

meagmohit · September 2018

Hi,

What are the pin connection diagrams for below post, if we want to provide the power directly from OpenBCI dongle (not through the battery pack of OpenBCI)?

http://docs.openbci.com/Hardware/06-Cyton_Radios_Programming_Tutorial#cyton-radios-programming-tutorial-uploading-device-firmware-to-cyton-board-program-device-radio-with-openbci-dongle

Thanks,

Mohit

meagmohit · September 2018

All,

figured it out, if anyone wants to do the same.

Just have to add one more jumper wire from the 3V3 pin of Dongle to pin 13 of RFDuino on device.

It's not too hard to hold the additional jumper wire.

Hope it helps!

Pin Connections to Program Device RFDuino [while providing power from dongle 3V3]

Comments