Stuck at “Attempting to establish a connection with your OpenBCI Board…”

Pierogi · July 2018

Hi,

I bulid my own Cyton and Dongle. I succeded to program Radios and PIC. I get "System i s up" messege in GUI, but after strarting it shows “Attempting to establish a connection with your OpenBCI Board…” and then i get error. Can You help me please?

wjcroft · August 2018

Are both RFduinos (dongle and mainboard) on the same radio channel? See Autoscan section,

http://docs.openbci.com/Tutorials/01-Cyton_Getting Started_Guide#cyton-getting-started-guide-iv-connect-to-your-cyton-board-from-the-gui-6-optional-settings

William

wjcroft · August 2018

You can also connect a terminal emulator to your dongle COM port and enter a '?', which should print config information.

Pierogi · August 2018

Thank you. I managed to get cyton working. Everything works, cyton communicate with dongle and data is transfered. Only problem is that i have to program pic on reference board, because it doesn't work on cyton board. I am not sure if LED should blink when its in bootloader mode, but it doesn't, and it seems like i cant put pic into bootloader mode on cyton, but i can on reference board. Is there anything i could do? My reference board is chipKit DP32.

Stuck at “Attempting to establish a connection with your OpenBCI Board…”

Comments