Hi there
I am struggling to find how to connect the cap up to the boards
I saw somewhere that the cap had the old numbering and I cannot find an exact mapping
Could someone please help me?
These electrodes map to labels on the electrodes. Please note that the cap uses older labelling, and that T3, T4, T5, and T6 were updated to be T7, T8, P7, and P8, respectively. These placements are interchangeable, and while the labels on the cap use older naming, they correspond to nodes on the diagram.
Hi there
Sorry to ask again.
These are the available electrodes I have
CZ
F3
F4
F7
F8
FZ
GND
P3
P4
PZ
REF
T3
T4
I need to connect these onto the daisy board? I am still really not getting it.
Comments
Claire, hi.
The default channel to head position is shown in this thread.
https://openbci.com/forum/index.php?p=/discussion/1087/connecting-mark-iv-to-cyton-including-daisy-board/p1
I assume you've also seen this page below. But I'm kind of surprised it does not show a similar channel to location map.
https://docs.openbci.com/AddOns/Headwear/ElectrodeCap/
William
The 'docs' link above states:
Hi there
Sorry to ask again.
These are the available electrodes I have
CZ
F3
F4
F7
F8
FZ
GND
P3
P4
PZ
REF
T3
T4
I need to connect these onto the daisy board? I am still really not getting it.
thanks
There is an open issue on the Docs that can fix this, if resolved.
https://github.com/OpenBCI/Documentation/issues/63
Sharing this thread to increase the priority of this Docs issue.