Cyton board Dongle (RFD22301) part is EOL [resolved]
arpit
india
I want to make a cyton board with my own and the dongle
but the problem is (RFD22301) part is OBSOLETE.
what should i do now? and How to proceed further?
what are the steps should I have to follow to make the cyton board working with Bluetooth ?
please provide proper documentation. or
provide steps so that everyone
can make it.
hope someone will reply.
Awaiting for your response.
Thanks,
arpit
Comments
I had also gone through this page:
https://openbci.com/forum/index.php?p=/discussion/1701/rfd22301-is-not-available-reason-obsolete
But i didn't get proper steps to proceed further !!
please give some guidance regarding
How to make cyton board and dongle
1)Bluetooth module such as
https://www.amazon.in/REES52-Wireless-Bluetooth-Transceiver-Arduino/dp/B00JP05S6C
or
2)cyton board with wifi module such as node MCU ESP8266
which way should I go and how?
awaiting for response
thanks,
arpit
peace
RFD22302 is also not Available !!! what should i do now ?
https://openbci.com/forum/index.php?p=/discussion/comment/12364/#Comment_12364
Respected sir,
Still i didn't get proper steps what to do ? And how ? I m beginner.please give proper guidance
How to build cyton and upload the bootloader and firmware without using rfduino or
How to do this by using wifi shield ?
Awaiting for your resposne
Thanks,
Arpit
Here is another thread showing how to Build-It-Yourself, using wifi shield instead of the RFduinos.
https://openbci.com/forum/index.php?p=/discussion/comment/10379/#Comment_10379
And as mentioned previously, you can also do it as a usb connection through a usb isolator.
Respected sir,
Were should i get non 3d printed parts ?
Or there are any alternatives available so that it will work with ultracortex headset ?
Awaiting 4 your response.
Thanks arpit
Arpit, hi. The thread title here is regarding how to work around the EOL of the RFduino. I think you have the answer.
Regarding the Ultracortex electrode holders + electrode (flat, spikey, comfort), those must be purchased on the shop page as you have shown. These holders are injection molded, because of the very small dimensions and close fitting. They cannot be produced with 3D printing.