Bioera Support

compujohnny · April 2019

Can you use the Wifi Shield with Bioera? if so what design elements will you use to accomplish this?

I asked on Bioera forum but Jarek is not sure and says it depends if it requires an additional driver or not

Any help is appreciated

wjcroft · April 2019

John, hi.

Here is the easiest way to do this:

* Use the OpenBCI_GUI to capture your EEG from Cyton or Ganglion with the Wifi Shield.

* Use the GUI 'Networking Widget' to send an output stream in LSL format (LabStreamingLayer)

* use the LSLAcquisition element in BioEra to receive the stream.

[list of devices supported, including LSL at bottom]

Regards,

William

compujohnny · April 2019

Thanks William, I will give it a try and let you know if I ran into any issues

wjcroft · April 2019

Try the lowest speeds first. In order to get higher speeds with the shield, you need to use the UDPx3 mode, NOT TCP.

Comments