Daisy Module Not Recognized by GUI

JabernetJabernet Seattle
in Cyton
Hello,

I've been having trouble getting the 16 channel daisy module to be recognized by the V3 - 32bit board/GUII. I've checked all the solder points with a voltmeter and they seem fine. The solder job isn't my best work, but it doesn't seem any worse than what I've seen in the forum when looking for solutions to this issue. I've tested this using the x64 and processing versions of the GUI. A bit at a loss on how to move forward, so I wanted to reach out for advice before attempting to resolder or using a different board. Below is a screencap of the GUI showing only the 1st 8 channels.

Thanks!

image
Sign In or Register to comment.

© Vanilla Keystone Theme 2026