To use the pin D12 as an input
Hello all,
I have seen somewhere in the forum that Pin D12 can be used as an input.
I also saw on the Obci32 schematic that D12 ( called "PQC" , it's
difficult to read) , goes to the RFDUINO MODULE, pin 6 (QPJO5).
I would like to use D12 because, on J3 connector, it is just by the ground and +3.3V, it is very convenient...
Therefore I would like to be sure that to use it as an input, incoming signal will not disturbe the Rfduino module.
Is it ok, it doesn't matter ?
Sincerely ,
y.j.
I have seen somewhere in the forum that Pin D12 can be used as an input.
I also saw on the Obci32 schematic that D12 ( called "PQC" , it's
difficult to read) , goes to the RFDUINO MODULE, pin 6 (QPJO5).
I would like to use D12 because, on J3 connector, it is just by the ground and +3.3V, it is very convenient...
Therefore I would like to be sure that to use it as an input, incoming signal will not disturbe the Rfduino module.
Is it ok, it doesn't matter ?
Sincerely ,
y.j.
Comments