16 channel: "init timeout" / 8 channel OK

Sifeng · September 2015

the channel count is 16, "Init timeout verify your Serial/COM Port"

the channel count is 8, everything is ok

Sifeng · September 2015

Sifeng · September 2015

the picture:https://www.dropbox.com/s/8jp3pyzr3u1yhk5/16 Channel.jpg?dl=0

biomurph · September 2015

Hi Sifeng,

Do you have the Daisy Module attached? Has it worked before?

The Processing GUI will output debug messages in its console (the black window below the code window)

Please send that output to better debug with you.

wjcroft · September 2015

@Sifeng , hi.

You mentioned this on a previous thread, and Joel suggested that you confirm you have the 16 channel firmware loaded. Did you do that?

[entire thread of which that post was a part]

Comments