Wifi Shield connectors slightly off?

ncnaretncnaret no
in Wifi Shield

Hi,
I bought a kit including a cyton+daisy, but I was waiting until the wifi shield was finally available again, which I finally arrived. Now that I have it, I've setup the wifi connection and then I was about to stack the cyton|wifi|daisy boards, yet while cyton|daisy fit perfectly, the 16 pins of the wifi-shield are like 1-2mm offset to the center (and therefore the socket on the other side of the wifi-shield is also offset for the daisy pins).
With some force, I could probably get these boards kind of stack, but I'm not sure whether that's supposed to be that way. (This is my first time setting up these devices, hence I rather ask stupid questions than break it).

Can someone official confirm that this is fine and stacking could be a little bit 'rough'?

Comments

  • wjcroftwjcroft Mount Shasta, CA

    Ncnaret, hi.

    Please send an email to contact at openbci.com, perhaps including some photos showing the misalignment. It's possible there was a manufacturing glitch in the Shield that you have.

    Regards, William

Sign In or Register to comment.

© Vanilla Keystone Theme 2026