Issue with analog read (Pulse)
roguetheory
London
I have everything set up and seemingly working on my Macbook Air, but as of this morning, I'm running into an issue after setting up on Imac. GUI on my Imac says "August" when loading up, one on Imac says "Novemeber".
Issue one:
On my Macbook air (August GUI) I have the pulse reader plugged in to: Red > DVDD, Black > GND and Purple> D11, when starting the Data Stream in the GUI,
when I click on "Turn Analog Read On" for the pulse widget, the blue light on the Cyton starts flashing and I can see some sort of reading on the widget.
The problem is it's not accurate and fluctuates wildly, up to 200bpm, to 58 bpm and so on. This is despite keeping my finger on it continously for 2 minutes, hoping for
it to stabliaze at the correct pulse. Unfortunately it doesn't happen.
Issue two:
On my desktop Imac, I have the pulse reader plugged in to: Red > DVDD, Black > GND and Purple> D11, when starting the Data Stream in the GUI (November GUI)
when I click on "Turn Analog Read On" for the pulse widget, all the data stream for EEG Time series stops and I'm not getting any
pulse detection. When I turn analog read off for the pulse widget, it starts again, yet still no pulse detection.
Any suggestions?