Cannot connect Cyton with PC using Bluetooth CSR dongle
Trying to get the Mark IV EEG up and running by connecting Cyton
8-channel to the OpenBCI GUI on Windows 10.
Niklas
8-channel to the OpenBCI GUI on Windows 10.
- I have installed the CSR Bluetooth dongle and the Harmony software (v 2.1.63). In the settings I see:
Ports (COM & LPT):
Bluetooth SPP Driver (COM3)
Bluetooth SPP Driver (COM4)
When I look at driver details, it says Cambridge Silicon Radio Limited
- I install the VTDI drivers as instructed. I used the setup.exe file. (I am not sure how to confirm that this was successful).
- I flip the switch on the Cyton board to "BLE". I see a solid blue light.
- I open the Harmony software and choose "Add New Device". No device is
found. I flip both the Cyton switch and the PC Bluetooth switch a couple
of times. However, the PC/Harmony detects my iphone and successfully
pairs with it.
Niklas
Comments
So, I followed the Cyton instructions. The first steps works well. I get to the point where I have the OpenBCI GUI software up, it shows "COM5" and I get a "Success" Status. When I click "Get Channel" I see that I have channel 20. Now I click "Start System". The footer says "Attempting to connect". Then nothing happens. I tried re-doing all steps. Same result.
Thanks!
https://github.com/OpenBCI/OpenBCI_GUI/releases/tag/v3.2.0