Cyton

Sub-category for the Cyton 8/16 channel system

Discussion	Started By	Replies	Views	Most Recent
Identical FFT and Time-Series Signals Across Channels on Cyton + Ultracortex Mark III	nugroho_budi August 11	11	55	nugroho_budi August 14
All channels with the same signal	SpaceDonut March 2024	15	271	nugroho_budi August 11
Unipolar signal recording on plants	a_melis July 20	8	223	wjcroft July 21
Cyton Board + Cyton Radio Dongle Cannot Connect After Long Storage — Firmware v1.0.0 Issue?	nugroho_budi May 30	17	315	nugroho_budi July 8
Supplemented tutorial for Cyton Radios programming	danysab March 10	2	322	danysab July 7
How to Process EEG Data with Large Amplitudes After High-Pass Filtering	jiongjiong June 21	1	238	wjcroft June 23
high impedence	gg_022006 May 29	11	269	gg_022006 June 4
Using cEEGrid for trigeminal / jaw reflex electrophysiology	Frisardi56 May 27	3	231	wjcroft May 28
TTL trigger output synchronization for external electrical stimulator	Frisardi56 May 27	1	215	wjcroft May 27
Cyton long term measurements power supply	a_melis April 15	1	130	wjcroft April 15
huge numbers while getting data from the cyton	eya April 9	5	210	wjcroft April 13
Issue on Firmware Update and Cyton Working	Raghul April 2	1	153	wjcroft April 2
Issues with failure to retain data stream and packet loss with a Cyton+Daisy system	shatch10 March 15	1	155	wjcroft March 16
OpenBCI GUI connection error	smanne March 14	1	159	wjcroft March 15
Understanding serial connection via Dongle w/ Cyton	smanne March 1	11	262	wjcroft March 15
How to match the imported channel numbers with the channel names in eeglab?	mx_D March 11	2	153	mx_D March 13
latency	gilad March 4	2	158	wjcroft March 6
Signal polarity (sign) in Cyton data	ginom February 12	1	156	wjcroft February 12
Sending triggers to Cyton AUX pins	cgontier January 28	6	214	wjcroft February 6
Streaming Accel/AUX data via the Networking widget	cgontier February 5	0	152	cgontier February 5
Multiple Cyton's Simultaneously: (Packet Loss, Pairing, Signal Dropouts)	jean_diddy January 29	4	163	wjcroft January 30
Dongle not recognized / not being identified by the GUI.	kingbob_01 January 29	4	171	kingbob_01 January 29
What caused this abnormal (high frequency noise) phenomenon?	Zenton January 26	2	191	wjcroft January 27
Import channel locations using EEGLAB	Zenton May 2025	3	203	Zenton January 26
cEEGrid missing second half of channels (9–16)	Hendrik January 6	10	180	MKnierim January 9
The impedance test can't reduce the impedance on certain leads.	winterrrr December 2025	1	179	wjcroft December 2025
Bias feedback	fs_clar March 2023	6	1.4K	stellarpower November 2025
Cyton board not powering up [resolved]	todor November 2025	5	244	todor November 2025
Why is BiasOut run through 1M resistor in Series?	tdengineer November 2025	3	165	wjcroft November 2025
Impedance measurement	LR__07 October 2025	4	323	wjcroft November 2025