This is not done on the openBCI Cyton. Any reason for this? I choose R and C values to give a Fc of 6.7kHz as used in the ADS1299EEG-FE Eval Board. Although they still connect to Agnd as seen in the s

http://openbci.com/forum/index.php?p=/search&Search=ADS1299EEG-FE

Thanks for the reply. I am using Intel Edison to control ADS1299 via the SPI bus. I connected Edison to the upper card of the ADS1299EEG-FE development kit. I am supplying this card with a 3.3 V as di

Then I decided to use ADS1299EEG-FE Daughter Card separately with Arduino DUE.

I was working ADS1299EEG-FE for a past few week but I have been stuck as the