Would anyone happen to know how to configure the demo design so that the generic single channel board element is replaced with the ganglion element? I have already tried inputting the correct element…

While OpenBCI boards DO support neurofeedback apps (such as BrainBay, neuromore, OpenViBE, BioEra, etc.) these apps are not what is generally considered 'consumer-grade' easy-to-use apps for novice us

but then the time series will show railed. Brainbay also does not show any signal. I am using nuprep and 10-20 paste. Yesterday, I was able to hold good signal with one electrode for over an hour, wh

but then the time series will show railed. Brainbay also does not show any signal. I am using nuprep and 10-20 paste. Yesterday, I was able to hold good signal with one electrode for over an hour, wh

The math on how much delay a filter creates is going over my head. I may dig into this later on. Brainbay also does not have a way to show the delay from filtering.

The math on how much delay a filter creates is going over my head. I may dig into this later on. Brainbay also does not have a way to show the delay from filtering. I accept that if I have a single fi

that many of these apps (Bioexplorer, BioEra, BrainBay, etc.) have a way to display the graph of delay vs frequency for each filter that you implement. The digital filter delay is unavoidable and is

I am currently using Cyton with Bluetooth and Brainbay for neurofeedback software.

In your annotation (1), tying two separate outputs to one input is actually illegal in dataflow / VPL systems like this. BrainBay would have likely complained if you had tried to run this design. But

William: quick question about your BrainBay example you gave above (located here: https://sites.google.com/site/biofeedbackpages/brainbay-openbci/neurofeedback)

Neuromore is free. As is BrainBay, OpenViBE, etc.

If you want to train on 1 through 8 Hz, use one of the VPL apps such as BrainBay, neuromore, etc.

BrainBay 'devices' are sometimes confusing. My understanding is that both the OLD OpenBCI devices based on the 'Hub' concept, AND the newer devices based on Brainflow library are both present. You mus

I have the Ganglion board and tried BrainFlow (loaded from here: https://github.com/ChrisVeigl/BrainBay/releases, just loaded and installed "Setup_BrainBay.exe") , but for some reasons get e

Also see BrainBay, which uses similar VPL dataflow setup.

Your 2nd question may be better addressed with apps tailored to neurofeedback applications, such as BrainBay, neuromore, BioEra, NeuroPype, etc. All of these accept OpenBCI data streams. Some of them

Is your Brainbay using the Brainflow drivers? There might be more than one device choice in their menus.

I would suspect your BrainBay design, might be impacted by possible noise issues. For example mains noise may contaminating your output graphs. Are you applying in addition to the bandpass, a notch fi

I purchased my Ganglion in spring 2023. Recently, I noticed that something seems off about its EEG. Upon further experimentation, using completely new gold plated cups, I noticed that my "alpha&q

You can program any feedback you desire with BrainBay or BioEra. Other apps also exist that are similar (VPL Visual Programming Language, using flow diagram.) Such as Neuromore, OpenViBE, PureData, Ma