I just realized that a Cyton Board can only communicate with its specific Dongle, has anyone encountered the same situation?
When uploading the firmware to Cyton, I tried to use two Dongles, and the upload was just possible with one of them.
One Comment
Leave a Reply
You must be logged in to post a comment.
Hi,
This is a great example of a question that should be posted to the forum. It actually has been answered previously.
You can hit “autoscan” in the GUI to connect the Dongle to any Cyton. Make sure first that only one Cyton at a time is powered on in the room.
Check out the Cyton tutorial section below for details on using Autoscan
http://docs.openbci.com/Tutorials/01-Cyton_Getting%20Started_Guide#cyton-getting-started-guide-iv-connect-to-your-cyton-board-from-the-gui-6-optional-settings