Compound Nerve Action Potential measurement?

SeagullSeagull Ukraine
edited January 2017 in Research
Hello! I am a newbie.
Could you please help me with my question.
 
Is it possible to measure Compound Nerve Action Potential (CNAP) in small animals during surgery with Open BSI board? This procedure needs pair of needle simulation electrodes and two pairs of recordings electrodes. The some parameters of a signal you can see here

http://www.medicine.mcgill.ca/physio/vlab/cap/character.htm


Thank you in advance.


Comments

  • wjcroftwjcroft Mount Shasta, CA
    Should work. You can set the voltage range / scale on the OpenBCI boards anywhere from microvolts (EEG) to millivolts (ECG, EMG, your action potentials). I assume your stimulation electrodes are provided by some other equipment? Could be possible by driving from OpenBCI, but considerably harder and would need custom circuit and firmware. Best to use your existing stimulator.
Sign In or Register to comment.

© Vanilla Keystone Theme 2025